![]() Your actual device name may be different. For a standard 1.44 MB floppy disk, low-level formatting normally writes 18 sectors of 512 bytes to each of 160 tracks (80 on each side) of the floppy disk, providing 1,474,560 bytes of storage on the disk. In the following examples, the floppy disk drive device name is given as /dev/rdsk/fds0d3.3.5. NFORMAT is a floppy disk formatter that lets you control many of the low level details of the formatting process and file system. The low-level format of floppy disks (and early hard disks) is performed by the disk drive's controller. The tar, cpio, and dd tools are usually available on all UNIX systems. Also, whenever possible, change directories to the directory that contains the file and place the file on the floppy disk using a relative pathname, rather than specifying the absolute pathname.Īlso be aware that using a floppy disk to transfer files to systems made by other manufacturers may mean that the same tools are not available on the receiving system. This makes it easy for you (and others) to retrieve the files from the floppy disk. When you place files on a floppy disk, make a note on the disk label of the format or the exact command used to place the files on the floppy disk. See the mkfp(1M) reference page for additional information. ![]() Use the mkfp command to format an unformatted floppy. Use the standard tape archive commands to write files to the floppy disk if the disk is formatted. You can use a floppy disk drive like a tape drive for IRIX file transfer. ![]() Using a Floppy Disk Drive for IRIX File Transfer ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |